CEMB SM628 Manual De Uso página 33

Note:
The rest is fully inserted when the small roller touches the upper edge of the rim.
While inserting the rest, the upper bead must not enter the rim housing on which
the inflation pressure sensor is mounted; doing so might damage it.
6.4.4 Mounting the lower bead
(Common procedure for Pax System with full width and clipé rest)
- Remove the lower bead from the lower edge of the rim using a standard lever (better
if protected by a plastic sheath) fig. 51
- Place the selector (E) on position 3
- Move the cylindrical roller to the lower part of the tyre
- Press the roller onto the edge of the rim
- Couple the bead inserter (K in fig. 8) to the wheel support shaft and insert the mount
hook between the rim and the bead, at about 10 cm from the roller fig. 52
- Put the bead in its housing, rotate the wheel at minimum speed and while advancing
gradually, stop before the bead inserter interferes with the roller.
- At completion release the bead inserter from the wheel
6.4.5 Mounting the upper bead
(Common procedure for Pax System with full width and clipé rest)
- Replace the double roller tool with the cylindrical roller
- Move the cylindrical roller to the upper part of the tyre
- While acting on the pneumatic lever switch (G), press the roller onto the edge of the
rim fig. 53
- Couple the bead inserter (K in fig. 8) to the wheel support shaft, and insert the mount
ook between the rim and the bead, at about 10 cm from the roller fig. 54
- Put the bead in its housing, rotate the wheel at minimum speed and while advancing
gradually, stop before the bead inserter interferes with the roller.
User's manual
WARNING
51
EN
52
33