Tool Assembly - Milwaukee 4270-20 Manual Del Operador

Ocultar thumbs Ver también para 4270-20:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To reduce the risk of injury, always unplug
tool before attaching or removing accessories
or making adjustments. Use only specifically
recommended accessories. Others may be
hazardous.
Attaching Feed Handles and Grips (Fig. 1)
Fig. 1
1.
Assemble the feed handles and grips to the hub. Tighten securely.
2.
To mount the hub to either side, align the two (2) dowel pins on the
hub with the holes in the pinion. Tighten the handle screw.
Stop Knob (Fig. 2)
The stop knob is designed to stop the slide from moving.
To install, screw stop knob into location shown (Fig. 2).
Fig. 2
Stop
knob

TOOL ASSEMBLY

WARNING!
Adjusting the Gib Assembly (Fig. 3)
Fig. 3
To adjust the gib, loosen or tighten the gib adjustment set screws on the
side of the support housing accordingly with the 3/32" hex key provided.
Tightening the set screws increases friction on the slide. The gib should
be set tight enough to support the weight of the drill in any position. All
adjusting screws should be set to provide smooth and even travel over
the entire length of slide movement.
The set screws contain a nylon patch that prevents them from moving
freely. Additional adjustment of the gib may be required from time to time
with extended use of the tool.
Adjusting the Support Bracket and Spacer for Depth of Cut
(Figs. 4 & 5)
This unit is shipped from the factory set for 1" depth cutters (Fig. 4).
Fig. 4
Spacer
When using 2" depth cutters, install support bracket with spacer on
bottom, as shown in Fig. 5.
Fig. 5
Spacer
NOTE: Do not use a spacer and support bracket with chuck adapter.
Support bracket
Support bracket
page 7

Publicidad

Tabla de contenido
loading

Tabla de contenido