Replacing The Lamp - AEG SCS51800S1 Manual De Instrucciones

Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.

6.1 Replacing the lamp

CAUTION!
Disconnect the plug from the
mains socket.
Possible cause
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regula-
tor is not set correctly.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
The temperature regula-
tor is not set correctly.
ENGLISH
Solution
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower temper-
ature.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the
door".
Set a higher temperature.
11