Cleaning The Boiler - SOLAC LV1301 Instrucciones De Uso

on, indicating that the steam cleaner is recov-
ering the necessary pressure.
We recommend pressing the control (2) re-
•
peatedly for short bursts rather than just a
few times for longer periods, so as to maintain
pressure in the reservoir.
When finished using the steam cleaner, set the
•
on/off switch to the off position (0) and discon-
nect the device from the mains, wait for it to
cool down to remove the attachments.
ATTACHMENTS
Taper nozzle (10)
Insert the taper nozzle (10) in the mouth (4) by
•
lining up the lugs on the taper nozzle with the
holes in the mouth (4) and turn it clockwise as
far as it will go (Fig. B).
Round brush (8) and angle nozzle (9)
Fit these accessories in the taper nozzle (10)
•
or flexible hose (14) (Fig. D and E).
Flexible hose (14)
If you want to reach inaccessible places or the
•
area to be cleaned is too far away, use the flex-
ible hose.
Fit the hose on the appliance as explained for
•
fitting the taper nozzle (10).
Fit any of the accessories accompanying the
•
appliance to the hose, from the flat side.
Window and fabric cleaning accessories
(11-12)
Use these accessories for cleaning floors, win-
•
dows, furniture, sofas, fabrics, and so on.
The cloth (13) can be used for cleaning such
•
delicate surfaces as sofas and armchairs.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Unplug the appliance to the mains.
•
Leave the appliance to cool down.
•
Empty the water out of the boiler. Make sure
•
the appliance is completely depressurized be-
fore opening of the safety cap.
CLEANING
Disconnect the appliance from the mains and
•
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
•
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid
•
or base pH such as bleach, or abrasive prod-
ucts, for cleaning the appliance.
Never submerge the appliance in water or any
•
other liquid or place it under running water.
HOW TO DEAL WITH LIME SCALE INCRUS-
TATIONS:
For the appliance to work correctly it should be
•
kept free of limescale or magnesium incrusta-
tions caused by the use of hard water.

CLEANING THE BOILER

Check that appliance has cooled down (wait
•
at least 3 hours after disconnecting the appli-
ance).
Does not force open the safety cap; make sure
•
the appliance is completely depressurized pri-
or to opening.
Fill the boiler with water and add the selected
•
anti-lime scale product.
Leave the product to
•
Shake vigorously and empty fully.
•
If necessary repeat this procedure.
•
EN