Wall Edge Castor; Abrasive Assembly Procedures - Kunzle & Tasin Bona Scorpion Manual De Funcionamento

Machine Adjustment Procedures (Cont.)
Adjusting handle height (cont.)
5) Tighten the screws (A).

Wall edge castor

A support with a free castor has been fitted to avoid damage to the skirting board or wall when sanding along the wall.

Abrasive Assembly Procedures

Fit the abrasive to the drum ensuring that the abrasive protrudes approximately 1.5mm from the drum itself.
Do not start the machine without the abrasive inserted, otherwise the drum will be damaged and must be
replaced.
The abrasive is in the correct position when it protrudes approximately 1.5mm from the sander drum.
Using a damaged abrasive may cause damage to the machine or floor.
Using a damaged abrasive which could then tear while sanding may damage the machine or floor.
18 18
6) Insert the bar (A) into the cylinder (B) and
lower the tube (C).
Before starting work, position the castor
correctly by loosening the fastening screw
(A) on the support, moving the support
to the required position and tightening the
screw (A).
Bona Scorpion Manual
7) Lift the drum with the lever (A).
The wall edge castor is correctly
positioned when the machine is
approximately 8mm away from the wall
with the castor up against it.