Routine Maintenance; Sawdust Chamber (For The User); Drums (For The User); Wheels (For The User) - Kunzle & Tasin Bona Scorpion Manual De Funcionamento

Routine Maintenance

To keep the machine in good working condition the following items must be checked and serviced
regularly.

Sawdust chamber (for the user)

Vacuum the sawdust
chamber (A) regularly.

Wheels (for the user)

Remove dirt from the machine
unit and wheels regularly. Dirt
may cause uneven sanding.

Belt tension (for the user)

Check the belt tension every 500 hours of operation.
1) Remove the belt cover after removing the two
screws (A). Loosen the 4 motor fastening screws
(B).
If the belt is excessively worn it must be replaced.
Excessive belt tension may cause the premature failure of the ball bearings.
The drum belt must have a 10.5mm stretch with a center load of 30±3N.

Drums (for the user)

Dust bag (for the user)

2) Belt tension can be adjusted using the screw (A). After
adjustment, lock the motor fastening screws and replace the
belt cover (B).
Bona Scorpion Manual
Check the outer surface
of the drum (A) regularly.
Remove any dirt.
Remove the bag and shake it well to
remove sawdust.
Turn the bag inside out and wash it in
the machine in cold water to prevent
blockage of the pores and a decrease in
dust collection ability.
We strongly recommend the Bona DCS
as an alternative to the fabric bag.
EN
19 19