Commencing Operation; Instructions For Assembly Following Transportation; Instructions For Electrical Connection - Kunzle & Tasin Bona Scorpion Manual De Funcionamento

Commencing Operation

Instructions for assembly following transportation

To re-assemble the machine after transportation, proceed as follows:
1.
Insert the tube into its housing and
tighten the handle.
3.
Insert the plug in the socket.

Instructions for electrical connection

This machine only operates
with the voltage and
frequency shown on the
machine data plate. Before
connecting the cable to the
power supply ensure the
correct voltage and frequency
are available.
10
2.
Insert the bar (A) into the cylinder
(B) and lower the tube (C).
4.
Lift the drum with the lever (A).
DO NOT expose the machine to rain. This machine is
intended for dry use only. Keep the machine in a dry building
and DO NOT use it in damp or wet places.
If the machine is not connected correctly to the electricity
network, death due to electrocution may occur. To prevent
electric shocks always use a grounded three wire electrical
system. For maximum protection against electric shocks
use a circuit protected with a differential cut-out switch.
Tampering with the grounding plug in any way may result
in death from electrocution. DO NOT cut, remove or break
the grounding plug. If the socket does not match the plug
consult a qualified electrician.
Do not use the machine if the switch malfunctions.
Bona Scorpion Manual
Using the machine when not fully
assembled may cause injury or damage
to people or objects. DO NOT use the
machine when it is not fully assembled.
Keep all fittings tightly closed. Maintain
machine settings in accordance with
the specifications.
If the machine is used with
a damaged plug or power
supply cable, death may
occur from electrocution.
If cables or plugs are worn
or damaged in any way,
have them replaced by the
manufacturer or certified
machine repair center in order
to prevent risks to safety.