Hot Water Operation; Steam Operation - Mi-T-M HLP Serie Instrucciones De Operación

WARNING
risK of burn!
tHe Water temperature
c o u l d b e c o m e
Hot durinG Hot Water
operation. be cautious
WHen adJustinG pressure
or controllinG tHe triGGer
Gun and lance assembly.
IMPORTANT
WHen cold Water is beinG
p u m p e d i n t o
eXcHanGer and tHe burner
is on, condensation may form
on tHe coil and drip. tHis Will
GiVe tHe appearance of a
leaKinG coil particularly in
cold Humid WeatHer.
22

Hot Water operation:

. Follow the steps outlined for "COLD WATER OPERATION AND LIGHTING
PILOT VALVE." on page 2.
V e r y
2. Move the control switch to the "BURNER" position. On initial start-
up, water will begin turning hot in approximately 60 seconds and will
reach maximum temperature in approximately 3 minutes, provided the
trigger remains squeezed. The burner will stop firing when the trigger
is released.
At this point, the unit is operating as a hot water pressure washer. Be certain
to be extremely cautious when adjusting the pressure and controlling the
trigger gun and lance assembly to avoid the possibility of burns.
NOTE: While spraying, it is normal for the burner to fire intermittently. The high
t H e H e at
steam operation (Hlp-0703-0m10 only):
. Follow the steps outlined for "LIGHTING PILOT VALVE AND COLD
WATER OPERATION."
2. Turn unloader knob counterclockwise to the minimum setting.
at this point, the unit will operate as a steam pressure washer. be
extremely cautious when adjusting the pressure and controlling the
trigger gun and lance assembly to avoid the possibility of burns.
operatinG instructions
limit switch will cause combustion to cease when the temperature of
the discharged water exceeds the temperature setting of the switch.
Combustion will begin again when the water temperature drops
below the minimum setting.
HLP-SERIES Hot Water Pressure Washer Operator's Manual