Listening To The Ipod, Iphone Or Ipad; Supported Ipod, Iphone And Ipad Models; Connecting Your Ipod/Iphone; To Remove Adaptor For Ipod Or Iphone - Pioneer X-HM70-S Manual De Instrucciones

Listening to the iPod, iPhone or iPad

Listening to the iPod,
iPhone or iPad

Supported iPod, iPhone and iPad models:

th rd nd st
• iPod touch (4 /3 /2 /1 generation)
• iPod classic
• iPod with video
th th th rd nd st
• iPod nano (6 /5 /4 /3 /2 /1 generation)
• iPhone 4/3GS/3G
• iPad
Important
• Pioneer cannot under any circumstances accept
responsibility for any direct or indirect loss arising from
any inconvenience or loss of recorded material resulting
from the iPod failure.
Note
• This system has been developed and tested for the
software version of iPod/iPhone/iPad indicated on the
website of Pioneer (http://pioneer.jp/homeav/support/ios/
eu/).
• Installing software versions other than indicated on the
website of Pioneer to your iPod/iPhone/iPad may result in
incompatibility with this system.
• Once iPod or iPhone is connected to the unit it will begin
charging.
• You can recharge the iPad when the power is on or during
iPod Charge Mode.
• When connecting the iPad, use only an iPad dedicated
cable.
• Connect iPad to the USB terminal.
• iPod and iPhone are licensed for reproduction of non-
copyrighted materials or materials the user is legally
permitted to reproduce.
• Features such as the equalizer cannot be controlled using
this receiver, and we recommend switching the equalizer
off before connecting.

Connecting your iPod/iPhone

CAUTION
• When connecting an iPod/iPhone units, always use the
universal dock adapter provided with your iPod/iPhone, or
a commercially adapter designed to support iPod/iPhone.
The iPod/iPhone cannot be connected without a universal
dock adapter; attempting to connect an iPod/iPhone
without a universal dock adapter will cause damage or
malfunction.
• Unplug all accessories from the iPod or iPhone before
inserting it into the dock.
1 Open the dock cover by pulling up.
2 Attach the Universal dock adapter to iPod/iPhone
connector port on this unit.
• An iPod/iPhone universal dock adapter is not supplied
with this unit.
When attaching the Universal dock adapter, be sure to orient
the front-back directions of the Universal dock adapter
correctly. To attach, first place the protruding tabs on the
front side of the adapter into the depressions on the iPod/
iPhone connector port and press into position. When
attaching the adapter, be careful not to strike the connectors.
3 Connect your iPod/iPhone.
• If an iPod/iPhone is connected when this unit is in
standby mode, the power will turn on and playback of the
iPod/iPhone will begin.
iPhone
iPhone (bottom)
Dock connector
iPhone dock
iPhone connector

To remove adaptor for iPod or iPhone

Insert the tip of a screwdriver (" – " type, small)
into the adaptor hole as shown and lift upward
to remove.

To insert iPad adaptor

1 Insert the iPad connector to the iPad.
17
En