Listening To Usb Mass Storage Device/Mp3 Player; Connecting A Usb Device; Playing A Usb Device; Basic Playback Controls - Pioneer X-HM70-S Manual De Instrucciones

Listening to USB mass storage device/MP3 player

Listening to USB mass
storage device/MP3
player

Connecting a USB device

It is possible to listen to two-channel audio using the USB
interface on the front of this receiver.
 Switch the receiver into standby then connect your USB
device to the USB terminal on the front panel of this
receiver.
• This receiver does not support a USB hub.
• If iPad is connected, the unit will begin charging.
TIMER
USB mass
storage device

Playing a USB device

Important
• Pioneer cannot guarantee compatibility (operation and/or
bus power) with all USB mass storage devices and
assumes no responsibility for any loss of data that may
occur when connected to this receiver.
Note
• This includes playback of WMA/MP3/MPEG-4 AAC files
(except files with copy-protection or restricted playback).
• Compatible USB devices include external magnetic hard
drives, portable flash memory (particularly keydrives) and
digital audio players (MP3 players) of format FAT16/32. It
is not possible to connect this receiver to a personal
computer for USB playback.
• With large amounts of data, it may take longer for the
receiver to read the contents of a USB device.
• If the file selected cannot be played back, this receiver
automatically skips to the next file playable.
• When the file currently being played back has no title
assigned to it, the file name is displayed in the OSD
instead; when neither the album name nor the artist
name is present, the row is displayed as a blank space.
• Note that non-roman characters in the playlist are
displayed as '*'.
• Make sure the receiver is in standby when disconnecting
the USB device.
1 Switch on the receiver and your TV.
2 Switch the TV input so that it connects to the receiver.
3 Press USB on the remote control to switch the receiver
to the USB function.
Please Wait appears in the OSD as this receiver starts
recognizing the USB device connected. After the recognition,
a playback screen appears in the OSD and playback starts
automatically.

Basic playback controls

This receiver's remote control buttons can be used for basic
playback of files stored on USB devices.
• Press USB to switch the remote control to the USB
operation mode.
O
Important
If a USB Error message lights in the display, try following the
points below:
• Switch the receiver off, then on again.
• Reconnect the USB device with the receiver switched off.
• Select another input source (like CD), then switch back to
USB.
• Use a dedicated AC adapter (supplied with the device) for
USB power.
If this doesn't remedy the problem, it is likely your USB device
is incompatible.
19
En