Mediclinics M17A Manual De Instalación Y Utilizacion página 14

INTRODUCTION
The Hand dryers Speedflow family has the following technical features:
- Automatic operation (IR sensors).
- Adjustable range detection (50-230 mm)
- Motor speed adjustable.
- Vandal proof operation system (no more than 30 seconds of continuous
running).
- ADDAG compliance (ADA Accessibility Guideline).
INSTALLATION
Mains connection and regulations of motor speed and
range detection must be handled by an authorized
technician.
The appliance is supplied with the two lower screws screwed to the base that
secures the cover from the inside.
The cover should be removed in the following manner:
1. Screw the lower screws in a clockwise direction (CW) with the supplied
special tool until they are fully screwed in place (see figure nº 1).
2. Remove the cover by rasing it a slight angle until the upper securing tab is
freed (see figure nº 2). Remove the cover in a vertical direction without striking
the inside of the machine (see figure nº3).
WARNING: When the cover is removed, live parts of the
appliance are exposed.
During this operation do not:
- Damage any internal components, especially the electronic circuit housed
under the volute (see figure nº 4).
- Scratch the cove nor the IR sensor protection.