Care must be taken during this operation not to touch the electronic circuit that
is housed under the volute.
NOTE: a minimum distance of 40 cm (15.8") must be allowed between any
possible shelves, marble or washbasins (see figure 10). As far as possible,
reflecting surfaces should be avoided within the operating range of the IR
sensors.
MACHINE MUST BE HANDLED ONLY BY AN
AUTORIZED TECHNICIAN.
The hand-dryer must only be installed on a closed surface, such as a wall,
partition or similar.
Fig. 8
INSTALLATION
The appliance includes an electronic unit that allows the adjustment of:
Input power motor
-
Sensitivity (range of detection)
-
Switching the heater off
-
www.mediclinics.com
Fig 9.
Fig. 10