Technical Data - RIB KS2 24V Manual Del Usuario

closed anyway. It turns off only when the gate is totally closed.
This warning signal is not enabled during the programming procedures.
N.B.: 3W Max. If you overuse the push button panels or the lamps,
the control board logic system may be compromised,
resulting into a possible operation block.
T
ECHNICAL DATA
- Temperature range
- Moisture
- Power supply voltage
- Frequency
- Battey supply
- Weight without battery
- Power transformer
- Absorption max
- Transient power mains drops
- Max. capacity of the warning light - gate open -
- Max load flasher
- All the inputs must be used as clear contacts because the power
supply is generated inside (safe power) the control panel, and it has
been laid down in such a way to guarantee a double or strengthened
insulation in relation to the parts with dangerous power.
- Eventual external circuits connected to the outputs of the control
board or of the expander card must be carried out making sure that a
double or strengthened insulation is used in relation to parts with
dangerous power.
- All inputs are run by a programmed integrated circuit which does a self
check every time it starts operating.
0 ± 55°C
< 95% without condensation
230V~ ±10% (on request
120V±10% )
50/60 Hz
20-24,5Vdc
kg 3,0
130VA - V primary 230 Vac - V
secondary 18Vac
25 mA
100ms
12Vdc 3 W
(corresponding to 1 3W lamp
or to 5 LEDS with 2,2 k
resistance In series)
24Vdc 20W
G G
B B