Fermax iLOFT DUOX Manual De Instalador página 35

iL iL iL iL iLOFT DUO iL iL iL iL iLOFT DUO OFT DUOX X X X X OFT DUO OFT DUO OFT DUOX X X X X OFT DUO OFT DUO OFT DUO
OFT DUO
Auto-start button.
· Select the Block's or General Entrance's camera (depending on availability in the
installation, see Operations chapter: Auto-start).
Note: After establishing any communication with a panel, for the following 15 seconds
after ending it, if you re-press the auto-start button it will connect to this panel.
Lock Releases / Call Guard Unit Button.
· While in conversation with the Street Panel (only video or audio+video), pressing it
will activate the open door lock-release.
· Pressing this button whilst the monitor is on standby will result in a call being made
to the guard unit (where one exists).
F1
BF1 Button
Auxiliary function (negative output "-" / sending command
Auxiliary F1 function.
The F1 button and F1 terminal have the option of being configured. You can select
between Sending a negative (output) and Panic call to the Guard Unit (input).
· It is initially configured, by default, as an output and sends a negative "-".
· If Panic Day Mode is configured in the Guard Unit, Panic Call mode is automatically
configured in the monitors. Upon deactivating this mode in the guard unit, it also
deactivates the monitors.
Upon pressing F1 the corresponding command is sent by the bus. Besides, the F1
terminal acts as an input so that when you connect a button to it, when pressing it you
send a panic command to the guard unit.
Note: If you want to use relay ref. 2013 to control a device via the F1 button, you need
an additional 18 Vdc of power.
Button Menu: Adjustments and configuration.
· With the monitor on standby, press and hold this button for 1 second to go into User
configuration mode. See section «Programming: User Menu» section
· To access the:
- When the monitor is not programmed, it accesses the Administrator Menu. From
this menu, you can program the monitor according to your installation needs
- Once the monitor is programmed, it accesses the User Menu. From this menu, you
can access the user's settings to personalise them.
Page 9