External Equipment; Others - Panasonic SC-UX100 Manual Del Propietário

Sistema estéreo con reproductor de discos compactos
Ocultar thumbs Ver también para SC-UX100:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SC-UX100 PP TQBJ0973 En.fm Page 12 Saturday, August 13, 2016 5:06 PM

External equipment

You can connect a VCR, DVD player etc., and listen to
the audio through this system.
Preparation
• Disconnect the AC power supply cord.
• Turn off all equipment and read the appropriate
operating instructions.
Rear panel of
this main unit
Audio cable
(not supplied)
1
Connect the external equipment.
2
Press [RADIO/AUX] to select "AUX".
3
Play the external equipment.
To adjust the input level
1
Press [PLAY MENU] to select "INPUT LEVEL".
2
Press [R, T] to select "NORMAL" or "HIGH" and
then press [OK].
Note:
Select "NORMAL" if the sound is distorted during "HIGH"
input level.
Components and cables are sold separately.
If you want to connect equipment other than those
described, refer to the audio dealer.
Sound distortion can occur when you use an adapter.
12
Confidential
Until:
9 Jan 2017
DVD player (not supplied)
digital printing 

Others

Illumination
You can turn on or turn off the illumination on the system.
1
Press [SETUP] to select "ILLUMINATION".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Auto off
This system automatically turns off when you do not use
it for approximately 20 minutes.
1
Press [SETUP] to select "AUTO OFF".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
This function does not work when you are in radio source or
when a Bluetooth
device is connected.
®
Bluetooth
standby
®
This function automatically turns on the system when you
connection from a paired device.
establish a Bluetooth
®
1
Press [SETUP] to select "BLUETOOTH STANDBY".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
Some devices may take longer to respond. If you are
connected to a Bluetooth
®
device before turning off the
system, wait for a minimum of 5 seconds before connecting
to this system from your Bluetooth
®
Software version
You can check the software version of the system.
1
Press [SETUP] to select "SW VER." and then press
[OK].
The software version is shown.
2
Press [OK] again to exit.
device again.

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido