Play Timer; External Equipment; Using The Auxiliary Input - Panasonic SC-MAX8700 Manual Del Propietário

Play timer

(Except for Bluetooth
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1
Press [SETUP] to select "TIMER ADJ".
2
Press [Y, U] to set the start time and then press
[OK].
3
Re-do step 2 to set the end time.
4
Press [Y, U] to select the source you want to play
and then press [OK].
To start the timer
1
Prepare the source you want to listen to and set
the volume.
2
Press [SETUP] to select "TIMER SET".
3
Press [Y, U] to select "PLAY ON" and then press
[OK].
"#" is shown.
To cancel, select "PLAY OFF".
The system must be turned off for the timer to
operate.
To check the setting
Press [SETUP] to select "TIMER ADJ" and then press
[OK].
In standby mode, press [DISPLAY] two times.
Note:
•
The play timer starts at a low volume and increases
gradually to the preset level.
• The timer comes on at the set time every day.
• If you turn off the system and then turn on again while a
timer is in operation, the timer will not stop at the end time.
16
16
® , AUX 1 and AUX 2 source)

External equipment

Preparation
• Disconnect the AC power supply cord.
• Turn off all equipment and read the appropriate
operating instructions.
Note:
Components and cables are sold separately.

Using the auxiliary input

You can connect a VCR, DVD player etc. and listen to the
audio through this system.
SC-MAX8700
Rear panel of
this main unit
Audio cable
(not supplied)
SC-MAX4700
Rear panel of
this main unit
Audio cable
(not supplied)
1
Connect the external equipment.
2
Press [RADIO/AUX] to select "AUX 1".
3
Play the external equipment.
Note:
•
If you want to connect equipment other than those
described, refer to the audio dealer.
• Sound distortion can occur when you use an adapter.
DVD player
(not supplied)