ABB M22301 Serie Manual Del Usuario página 40

ABB-Welcome
1. The bottom of the device has screw holes for fastening on the wall according to the
illustrations above.
2. In addition, the bottom of the device can be affixed to the existing flush-mounted
box. The dimensions of the compatible flush-mounted box is shown in illustrations
above.
Wiring
Affix the bottom of the device and connect it according to the illustration. The insulated
section of the cable end must not be longer than 10 mm.
Settings
Set addresses of the preferred outdoor stations and the address of the indoor station on
the jumper. (See Chapter 4.5, Adjusting the device.)
|
— 39 —