Inserting/Changing The Battery; Attaching The Measuring Tool - Bosch Atino Manual Original

Line laser
C
6
Divergence
Battery
Operating time at least
Weight according to EPTA-Procedure 01:2014
Dimensions (length × width × height)
A) depending on surface characteristics and ambient conditions
B) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by
condensation is expected.
The serial number (9) on the type plate is used to clearly identify your measuring tool.
Assembly

Inserting/Changing the Battery

It is recommended that you use alkaline manganese batteries to operate the measuring
tool.
Do not use lithium-ion batteries. This may result in damage to the measuring tool.
u
To open the battery compartment cover (5), press on the locking mechanism (6) and re-
move the battery compartment cover. Insert the battery.
When inserting the batteries, ensure that the polarity is correct according to the illustra-
tion on the inside of the battery compartment.
Close the battery compartment before using the measuring tool.
If the battery is running low, the light-up ring (3) will flash yellow three times after the
tool is switched on. The measuring tool can be operated for approx. another 15 min.
Take the battery out of the measuring tool if you do not intend to use the tool for
u
a long time. When it is stored in the measuring tool for longer periods, the battery can
corrode and discharge itself.

Attaching the Measuring Tool

Selecting/changing the pad
The measuring tool can be attached to walls or other vertical surfaces. Depending on the
type of substrate, either the gel pad (14) including the gel pad holder (13) or the pin
pad (7) with 2 pins (8) can be used.
Bosch Power Tools
English | 19
Atino
15 × 15 mrad (full angle)
1 × 1.5 V LR6 (AA)
5 h
0.26 kg
124 × 115 × 62 mm
1 609 92A 5YH | (09.07.2020)
5