Cleaning And Maintenance; Technical Data; Ec Declaration Of Conformity; Paper Shredder Hsm Shredstar - HSM shredstar Serie Instrucciones De Servicio

7 Cleaning and maintenance

Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
may enter the equipment.
Oil the cutting unit when
cutting performance deterio-
rates or the device becomes
noisy, or every time you
empty the waste container.
• Squirt special cutting unit oil through the
paper feed across the entire width of the
cutting shafts.
• Without feeding in paper, run the cutting unit
in reverse (R).
 This loosens paper dust and particles.

9 Technical data

Cutting type *
Shred size *
Cutting ca pa ci ty per cycle
Cutting speed *
Shredded material container volume *
Voltage
Dimensions B x T x H
Weight
*
: only applies to the paper/card cutting unit

EC Declaration of Conformity

HSM GmbH + Co. KG, Austraße 1-9, 88699 Frickingen / Germany hereby declares that the machine, referred to here
as
document shredder HSM shredstar X15 / X18
corresponds to the health and safety requirements of the following EC directives listed below due to its conception and
design of the version in which it was put into circulation by us:
Low voltage directive 2006 / 95 / EEC
EMC directive 2004 / 108 / EC
Applied standards and technical specifi cations:
• EN 13857:2008
• EN 55014-2:1997 + A1:2001 + A2:2008
• EN 61000-3-3:2008
Frickingen, 10.01.2013
10
or 15 sheets of paper (80 g/m²)
17-18 sheets of paper (70 g/m²)
• EN 55014-1:2006 + A1:2009
• EN 61000-3-2:2006 + A1:2009 + A2:2009
i.V. Hubert Kötzinger - Head of Environmental Engineering Product Development
shredstar X15_X18
8 Disposal / Recycling
Electrical and electronic old devices
contain a variety of valuable materi-
als, but also hazardous substances
which were required for function and
safety. Incorrect disposal or handling
can be dangerous to your health and
the environment. Never dispose of old devices
in the household waste. Observe the current
applicable regulations and use the collection
points for returning and recycling electric and
electronic devices. Dispose of all the packaging
materials also in an environmentally-responsi-
ble way.
Cross cut
1/8" x 1 1/16" (4 x 27 mm)
1 CD (max. 1.2 mm thick)
or 1 credit card / store card
(
7.9 ft/min 40 mm/s)
6.6 gal (25 l)
120 V / 60 Hz
220 - 240 V, 50 - 60 Hz
15.6" x 10.6" x 22.5"
(
395 x 270 x 580 mm)
35.3 lbs. (16 kg)
english
01/2013