Cebora JAGUAR DOUBLE PULSE SOUND MIG 2035/MD Manual De Instrucciones página 16

The tip must therefore be cleaned more often, and
replaced if necessary.
C) The contact tip must always be firmly screwed onto
the torch body. The thermal cycles to which the torch is
subjected can cause it to loosen, thus heating the torch
body and tip and causing the wire to advance unevenly.
• Wire liner.
This is an important part that must be checked often,
because the wire may deposit copper dust or tiny shav-
ings. Clean it periodically along with the gas lines, using
dry compressed air.
The liners are subjected to constant wear and tear, and
therefore must be replaced after a certain amount of time.
• Gearmotor group.
Periodically clean the set of feeder rollers, to remove any
rust or metal residue left by the coils. You must periodi-
cally check the entire wire feeder group:
guide rollers, liner and contact tip.
8 ACCESSORIES
Art. 1242 Torch 3.5mt
Art. 2003 Pull 2003 torch with UP/DOWN command
on grip.
Art. 1241 Water-cooled MIG torch.
Art. 1683 Cooling unit
16
hasp, wire