Hilti HIT-ICE Manual De Instrucciones página 9

Product Information
– Always keep these instructions together with the product even when given to other persons.
– Read the safety data sheet before use.
– Check expiration date (month/year) imprint on the label. Do not use expired product.
– Cartridge temperature during usage: -23 °C to 32 °C / -10 °F to 90 °F.
– Base material temperature at time of installation: between -23 °C to 32 °C / -10 °F to 90 °F.
– Conditions for transport and storage: Keep in a cool, dry and dark place between 5 °C and 25 °C
/ 41 °F and 77 °F.
– For any application not covered by this document / beyond values specified, please contact Hilti.
– Partly used cartridges have to be used within 4 weeks. Leave the mixer attached and store under
the recommended storage conditions. If reused, attach a new mixer and discard the initial quantity of
anchor adhesive, as described at paragraph 8.
Installation instructions
Follow the illustrations on page 2-3 for the sequence of operations and refer to tables on page 4-6 for
setting details.
 Drill hole with a hammer-drill set in rotation hammer mode using appropriately sized
carbide drill bit.
 –  Clean hole: Just before setting an anchor/rebar, the borehole must be free of dust, debris,
water, ice/frost and other contaminants.
Method 1: Manual Cleaning
• Blow - 4 strokes with Hilti blow-out pump with the nozzle extended to the back of the hole
until return air stream is free of noticeable dust.
• Brush - 4 times with the specified HIT-RB brush size (brush Ø ≥ borehole Ø) by inserting
the round steel brush to the back of the hole with a twisting motion and removing it.
• Blow - 4 strokes with Hilti blow-out pump with the nozzle extended to the back of the hole
until return air stream is free of noticeable dust.
Method 2: Compressed air cleaning
• Blow from the back of the borehole with oil-free compressed air (min. 6 bar at 6 m3/h)
fully retracting the air extension 2 times until return air stream is free of noticeable dust.
• Brush 2 times with the specified HIT-RB brush size (brush Ø≥ bore hole Ø) by inserting
the round steel brush to the back of the borehole in a twisting motion and removing it. The
brush should resist insertion into the borehole - if not, the brush is too small and must be
replaced with a brush of appropriate brush diameter.
• Blow again with compressed air 2 times until return air stream is free of noticeable dust.
If required use extensions for air nozzle and brushes to reach back of deep hole.
 Unscrew the cartridge's cap.
 Screw on the Hilti HIT-M2 Mixing nozzle tightly. Do not modify the mixer in any way.
Use only the type of mixer supplied with the adhesive.
 Insert the cartridge into the Hilti HIT-MD 1000 dispenser.
Printed: 19.08.2016 | Doc-Nr: PUB / 5098739 / 000 / 03
Hilti HIT-ICE
en
9