dirna Bergstrom bycool COMPACT 1.4 Instrucciones De Montaje página 20

COMPACT 1.4
EN
Position the interior air distribution panel
11
on the front studs with (1) M6 wide-rimmed
washer and (1) M6 nut on each stud.
Tighten the nuts until the foam air duct
comes up against the unit's upper foam.
Important: The rubber ducting must
being run into the upper rubber of the
unit to avoid air leaks.
11
EPDM
Gasket
Cabin roof
Upholstey
Tighten the nut in point 10a until it comes
12
up against the top part of the interior air
distribution panel.
12
EPDM
Gasket
Cabin roof
Upholstey
Unit base
Nut M6
Stud M6
Unit base
Nut M6 (10a)
Nut M6
Stud M6
Rubber ductings
Rubber ductings
20
Air conditioning for vehicles
Foam
Interior air distribution
panel
Foam
Interior air distribution
panel