Tabla de contenido
Publicidad
GB
B. UNMOUNTING
1.
Remove cover cap from the lock, and press the cover cap on to the key bow. Open the lock with
the key (key cannot be removed when the lock is open).
2.
Hold the ball rod tight, pull out the handwheel, and turn it in the direction of the arrow thus
opposing the spring tension, until further turning is no longer possible.
Remove the ball rod from the reception tube by pushing it down.
Then the handwheel can be released because it will lock automatically in tensioned position.
In this context please also do notice the stand of the symbols on the handwheel as well as on
enclosed sketch "removable ball rod".
3.
Safely store the ball rod in the boot protected against soiling.
As already mentioned, the key cannot be removed in the tensed condition.
Fit dust cap in the towball socket.
C. TO BE OBSERVED!
Mounting and unmounting of the ball rod can be carried out without any problems with normal
hand strenght.
Never use any auxiliary means, tools, etc., because they could damage the mechanism.
Repair and dismantling of the removable towball can only be carried out by us as manufacturer.
No modifications may be carried out on the entire towing hitch.
Note down the key number for a later order, if necessary.
Stick on the information shield supplied, either near the towball mounting socket or inside the
luggage compartment, on a position easily, seen.
D. SERVICE NOTES
1.
In order to guarantee a correct function the ball rod and the reception tube have to be clean at
all times.
2.
Take care of regular maintenance of the mechanism.
Regularly grease, resp. oil the bearing points, sliding areas, and balls with resin - free
grease, resp. oil.
Schloß nur mit harz- und säurefreiem Öl behandeln
3.
If the removable ball rod is not used for a longer period, the locking mechanism should
be untensioned (locked position) to relieve the spring elements.
To relieve the mechanism press the release lever to the front.
4.
Before cleaning the vehicle with a steam cleaner the ball rod has to be removed
and the plug has to be inserted.
(The ball rod must not be steam-cleaned).
20
Publicidad
Tabla de contenido
