Safety Notes - Monacor PA ECM-550DM Manual De Instrucciones

1 Operating Elements and Connections
(Page 2)
1 Microphone with pop protection
2 6.3 mm jack as balanced output for connecting the
amplifier system
3 Switch for activating/deactivating the automatic
chime prior to and after an announcement
4 ON/OFF switch
5 Keypad for selecting the recording number
6 TALK button
7 USB jack for connecting a PC
8 Speaker
9 Supply jack for connecting the supplied plug-in
power supply unit
10 LC display
11 3.5 mm jack for connecting stereo headphones
12 POWER LED
13 Button RECORD for recording an announcement
message or any audio signal desired via the micro-
phone or the audio input (14)
14 3.5 mm stereo jack for connecting any signal
source desired with line level
15 Button PREVIEW for prelistening to a recording via
the speaker (8) or headphones connected to the
jack (11)
16 Button PLAY for replaying a recording
17 Button CANCEL/END to end a recording or to stop
a replay and correct the number entered
18 Short operating instructions; insert the card into the
guide rails on the lower side of the unit so that it
can be pulled out

2 Safety Notes

The units (the paging microphone and the supplied
plug-in power supply unit) correspond to all required di-
rectives of the EU and are therefore marked with
WARNING The power supply unit is supplied with
hazardous
Leave servicing to skilled personnel only.
Never make any modification on the unit,
otherwise you will risk an electric shock.
Please observe the following items in any case:
The units are suitable for indoor use only. Protect
them against dripping water and splash water, high
air humidity, and heat (admissible ambient tempera-
ture range 0 – 40 °C).
Do not operate the microphone or immediately dis-
connect the power supply unit from the socket
1. in case of visible damage to the microphone or to
the power supply unit,
2. if a defect might have occurred after a unit was
dropped or suffered a similar accident,
mains voltage (230 V~).
3. if malfunctions occur.
In any case the microphone or the power supply unit
must be repaired by skilled personnel.
For cleaning only use a dry, soft cloth; never use
water or chemicals.
No guarantee claims for the units and no liability for
any resulting personal damage or material damage
will be accepted if the units are used for other pur-
poses than originally intended, if they are not cor-
rectly installed or not repaired in an expert way, or if
the software is not correctly installed.
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful to
the environment.
3 Applications
The paging microphone ECM-550DM is specially de-
signed for PA systems. It is equipped with switchable
chimes at the beginning and the end of each an-
nouncement and allows recording and replay of music,
audio signals, jingles, or announcements which are
frequently made. The maximum number of recordings
is 89. It is possible to prelisten to these recordings via
the integrated speaker or headphones connected and
to interrupt the replay for important announcements.
The storage capacity is 64 MB, corresponding to a
total recording time of approx. 60 minutes (at a data
rate of 128 Kbit/s).
4 Connections
1) Connect the output (2) via the supplied cable to the
input of an amplifier or mixer. The output is bal-
anced, however, unbalanced connection is also
possible.
2) For recording from a signal source with line level
(e. g. CD player), connect the signal source to the
.
audio input (14).
3) Connect headphones to the jack (11). In this case,
the speaker (8) will be switched off.
4) Connect the low-voltage plug of the power supply
unit to the supply jack (9), then connect the power
supply unit to a mains socket.
5) For recording management by means of a PC,
connect the small plug of the USB cable supplied to
the jack (7) and the other plug to the PC. For com-
munication with the PC, it is not necessary to
connect the power supply unit as power will be sup-
plied via the USB cable in this case.
GB
7