DeWalt DCD700 Manual De Instrucciones página 38

• Do not operate the charger with a damaged cord or plug.
• Do not operate the charger if it has received a sharp blow,
been dropped or otherwise damaged in any way. Take it to
an authorized service center.
• Do not disassemble the charger; take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 120V
household electrical power. Do not attempt to use it on any
other voltage. This does not apply to the vehicular charger.
Chargers
Your tool uses a D WALT charger. Be sure to read all safety
E
instructions before using your charger.
Charging Procedure (Fig. 1)
1. Plug the charger into an
appropriate outlet before
inserting the battery pack.
2. Insert the battery pack (H)
into the charger, as shown
in Figure 1, making sure
the pack is fully seated in
charger. The red (charging)
light will blink continuously,
indicating that the charging
process has started.
3. The completion of charge
will be indicated by the red light remaining ON continuously. The
pack is fully charged and may be used at this time or left in the
charger.
FIG. 1
H
Indicator Light Operation
DCB107
PACK CHARGING
PACK CHARGED
HOT/COLD DELAY
Charge Indicators
HOT/COLD PACK DELAY
DCB107
The DCB107 charger has a hot/cold delay feature. When the charger
detects a battery that is hot, it automatically delays charging until the
battery has cooled. When the charger detects a battery that is cold, it
automatically delays charging until the battery has warmed.
The red light will continue to blink, but a yellow indicator light will
be illuminated during this operation. Once the battery has cooled,
the yellow light will turn off and the charger will resume the charging
procedure.
LEAVING THE BATTERY PACK IN THE CHARGER
The charger and battery pack can be left connected with the charge
indicator showing Pack Charged.
WEAK BATTERY PACKS: Weak batteries will continue to function
but should not be expected to perform as much work.
FAULTY BATTERY PACKS: This charger will not charge a faulty
battery pack. The charger will indicate faulty battery pack by refusing
to light or by displaying problem pack or charger.
NOTE: This could also mean a problem with a charger.
36