Intended Use - DeWalt DCD700 Manual De Instrucciones

D
FIG. 2
F
C
A
G
H
DCD710

INTENDED USE

This drill/driver is designed for light fastening and drilling applications.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
These drills/drivers/hammerdrills are professional power tools. DO
NOT let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
E
B
E
J
Belt Hook (Fig. 2)
DCD710
WARNING: To reduce the risk of serious personal injury,
place the forward/reverse button in the lock-off position or
turn tool off and disconnect battery pack before making
any adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
WARNING: To reduce the risk of serious personal injury,
DO NOT suspend tool overhead or suspend objects from the belt
hook. ONLY hang tool's belt hook from a work belt.
WARNING: To reduce the risk of serious personal injury,
ensure the screw holding the belt hook is secure.
IMPORTANT: When attaching or replacing the belt hook, use only
the screw (J) that is provided. Be sure to securely tighten screw.
The belt hook (I) can be be attached to either side of the tool using
I
only the screw (J) provided, to accommodate left- or right-handed
users. If the hook is not desired at all, it can be removed from the
tool.
To move belt hook, remove the screw (J) that holds the belt hook
in place then reassemble on the opposite side. Be sure to securely
tighten screw.
Variable Speed Trigger Switch (Fig. 2)
To turn the tool on, squeeze the trigger switch (A). To turn the tool
off, release the trigger switch. Your tool is equipped with a brake.
The chuck will stop when the trigger switch is fully released.
The variable speed switch enables you to select the best speed
for a particular application. The further you squeeze the trigger,
the faster the tool will operate. For maximum tool life, use variable
speed only for starting holes or fasteners.
NOTE: Continuous use in variable speed range is not recommended.
It may damage the switch and should be avoided.
38