DeWalt DCD700 Manual De Instrucciones página 42

FIG. 4
To remove the battery pack from the tool, press the release button (G)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
Keyless Single Sleeve Chuck (Fig. 5)
Your tool features a keyless chuck with one rotating sleeve for one-
handed operation of the chuck. To insert a drill bit or other accessory,
follow these steps.
1. Lock the trigger in the OFF position as previously described.
2. Grasp the black sleeve of the chuck with one hand and use the
other hand to secure the tool. Rotate the sleeve counterclockwise
far enough to accept the desired accessory.
3. Insert the accessory about
3/4" (19 mm) into the chuck and
tighten securely by rotating the
chuck sleeve clockwise with
one hand while holding the tool
with the other. Your tool is
equipped with an automatic
spindle lock mechanism. This
allows you to open and close
the chuck with one hand.
To release the accessory, repeat
step 2 above.
WARNING: Do not attempt to tighten drill bits (or any other
accessory) by gripping the front part of the chuck and turning the tool
on. Damage to the chuck and personal injury may result. Always lock
off trigger switch when changing acces sories.
G
H
FIG. 5
40
Be sure to tighten chuck with one hand on the chuck sleeve and one
hand holding the tool for maximum tightness.
CHUCK REMOVAL (FIG. 6)
Turn the adjustment collar (D) to the "drill" position and gear shifter
(E) to position 1 (low speed). Tighten the chuck around the shorter
end of a hex key (not supplied) of 1/4" (6.4 mm) or greater size.
Using a wooden mallet or similar object, strike the longer end in
the clockwise direction, as shown. This will loosen the screw inside
the chuck.
Open chuck jaws fully, insert screwdriver (or Torx tool if required)
into front of chuck between jaws to engage screw head. Remove
screw by turning clockwise (left-hand-thread). Place hex key in
chuck and tighten, as shown in Figure 6. Using a wooden mallet or
similar object, strike key sharply in the counterclockwise direction.
This will loosen the chuck so that it can be unscrewed by hand.
FIG. 6
E
D
FIG. 7
E
D