Use Of The Hood; Remote Control; Control Panel - THERMEx MONSUN II Instrucciones De Uso

46
THERMEX MONSUN II

USE OF THE HOOD

This hood has:
• Edge suction with 4 speeds
•

Remote control

•

Control panel

• LED light
• Periodic extraction
• After-running
The hood can only be controlled using the remote control provided. The control panel is located on the hood itself and equipped with diodes and IR in-
dicator, which indicates which speed has been selected for the hood, as well as whether the "periodic extraction" or "after-running" functions have been
activated.
REMOTE CONTROL
The remote control is an IR remote. The top of the remote control must be pointing directly towards the IR receiver on the hood with nothing blocking
it.
EXTRACTION
The motor is activated by pressing the power button. The motor always starts at speed 1.
The motor speed is increased by pressing the (+) button and reduced by pressing the (-) button. The motor is turned off by pressing on the power button,
regardless of which speed it is running at.
CONTROL PANEL
The control panel is located on the hood. There are four diodes on the control panel as well as the IR receiver.
1
The motor's speed is indicated by the number of LED lights that are lighting on the control panel while it is running. One LED light lights at speed 1, two
LED lights light at speed 2, and so on.
1
2
1. On/off
3
2. (-) button
3. (+) button
4
4. On/off light.
When using the remote control for the first time, the accompanying batteries must first be inserted:
• Remove the protective film surrounding the batteries
• Remove the battery cover on the bottom of the remote control
• Insert the batteries, taking care to position them correctly.
• Replace the battery cover on the remote control.
• The remote control is now ready for use.
2 3
5. LED light 1
6. LED light 2
7. LED light 3
8. LED light 4
9. IR receiver
4 5
B 423262361211032016