Publicidad
EN
Rechargeable hair clipper Use Instructions
Description of the appliance Fig.A
1. Hair clipper head
2. Cutting length selector
3. ON/OFF switch
4. Display (20/40/60/80/100% charge indicator, charging symbol, lock symbol)
5. Protective cap or beard comb
6. Guiding comb 4-6 mm
7. Guiding comb 7-9 mm
8. Guiding comb 10-12 mm
9. Guiding comb 16-18 mm
10. Guiding comb 22-24 mm
11. Guiding comb 28-30 mm
12. Standing and charging base
13. Power/charging cable
14. Cleaning brush
Use and charge
The appliance can be used either in rechargeable mode as well as connected to the power supply using the
cable supplied. In this way, it is possible to continue using the appliance even if the battery discharges during
use, simply by connecting it to the power outlet.
To use the appliance corded, make sure that the product is switched off before plug in.
To recharge the device, you can:
a. Connect the power cord and recharge the appliance directly, inserting the connector in the appropriate slot at
the base of the hair clipper;
or
b. Connect the power cable to the support base, inserting the connector inside the appropriate slot. Once the
connector is fixed, simply place the hair clipper on the base, to start recharging it.
When the appliance is connected to the power supply, the LED charging indicator lights up red on the display,
and remains lit until the battery is fully charged.
During charging the charge level (20/40/60/80/100) will continue to flash until it reaches full charge (100).
Full charging takes about 90 minutes, for a continuous operation of about 90 minutes.
Caution: when recharging the product with the recharging base, take care to place it on a flat and stable
surface, away from water and / or heat sources.
Instructions for Use
The product is equipped with 4 different lengths (0.5mm; 1.0mm; 1.5mm; 2.0mm) selectable by using the ap-
propriate button on the side of the product.
The appliance has 6 guiding combs, with different sizes 4-6mm; 7-9mm; 10-12mm; 16-18mm; 22-24mm; 28-
30mm, and a beard comb.
To install the guiding comb and/or beard comb (figure C): position the guide comb on the blade then make sure
that both pins on the sides of the comb match with those on the side of the blade, push lightly until you hear a
slight "click".
To remove the guiding comb (figure D): grip the guiding comb by the side hooks and pull slightly outwards.
Cut the hair
First, comb the hair thoroughly, removing any knots.
Choose the desired cutting length and the guiding comb according to your needs.
Begin to cut, starting from the neck and proceeding half of the head.
When cutting, let the guiding comb remain attached to the scalp, then move the clipper back and forth.
It is advisable to cut the hair in the opposite direction of hair growth.
Cleaning and maintenance
Before cleaning the appliance, make sure it is switched off and unplugged.
Remove all the accessories, and by using the brush supplied, remove the hair from the blades, for an accurate
cleaning it is also possible to remove the blade, pushing it slightly outwards as shown in figure E.
The head of the hair clipper can be washed with running water, being careful not to let the water penetrate the
body of the product, and drying it carefully immediately afterwards.
Do not immerse the appliance in water. Clean the appliance body with a slightly damp soft cloth.
11
Publicidad
