Cover Fiber Pyrocondensation Tude; Preparation Of Fiber End-Face - ADInstruments AD300 Manual De Usuario

_____________________________________________________________________
When the display brightness is moderate, the capacity loss can be
reduced, and the endurance of the battery can be prolonged.

2.6 Cover fiber pyrocondensation tude

The installation of fiber pyrocondensation tude

2.7 Preparation of fiber end-face

2.7.1 Open the big and small clips of the cutter; push the sliding
plate installed with blade from the end to the front.
2.7.2 Use fiber stripping pliers to strip fiber coating layer, the length
of which is 30-40 mm. Use gauze dipping with alcohol or
wadding soft enough to wipe clean the fiber. Wiping with a
clean cotton cloth once, and do not clean it with the same cloth
for the second time. (Notes: Please use the alcohol with purity
more than 99%.)
©Copyright Abacanto Digital SA.
Manual de usuario AD300
AD Instruments
110