ADInstruments AD300 Manual De Usuario página 153

_____________________________________________________________________
Parameter
Title for a splice parameter file can be expressed in up to 15 characters.
File Name
The title is displayed in the [editing splice parameter files] menu.
The splicer has four options of Splice Mode: Auto, Calibrate, Normal, and
Splice Mode
Special, where in the first three are common options.
A list of splice modes stored in the splicer database is displayed. Upon
inputting the appropriate mode, the selected splice mode stored in database
Fiber Type
area is copied to a selected splice mode in user-programmable area.
An error message is displayed if the cleave angle of either the left or right
Cleave Limit
fiber ends exceed the selected threshold (Cleave limit).
An error message is displayed if the estimated splice loss exceeds the
Loss Limit
selected threshold (Loss limit).
Arc Power Under Auto/Calibrate fusion model, Arc power is fixed at 80bits.
Under Auto/Calibrate fusion model, Arc time is fixed at 1500ms and can't
Arc Time
amended.
A cleaning arc burns out micro dust on the surface of the fiber with an arc
discharge for a short period of time. The duration of the cleaning arc can
Cleaning Arc
be changed by this parameter.
Under certain conditions, it shall be mended fusion loss through rearc time
Rearc Time
again. The duration of the rearc time can be changed by this parameter.
Proof Test If [Proof Test] is set to "ON", a proof-test is performed automatically.
©Copyright Abacanto Digital SA.
Description
Manual de usuario AD300
AD Instruments
153