Memory Clear Menu] - ADInstruments AD300 Manual De Usuario

_____________________________________________________________________
Realign after Pause
Number of manual
Rearcs
3.2.7 [Memory clear] menu
[Memory clear] menu offers options about the memory of
<1> The interface of [Memory clear] menu
A. In the "Splice Mode" menu, Press
the cursor to select the [Memory clear] menu, and press
There are 3 options in the [Memory clear] menu. See the
following picture.
B. Press
Splice Memory]; press
Splice Memory] interface is entered; in this interface, the
user can consult the splice results or change the name the
results
©Copyright Abacanto Digital SA.
After a long time in the [PAUSE] state, alignment may be lost.
Therefore, the splicer performs the realigning function after the
end of [PAUSE] state. Setting this function to "OFF" prevent
the realignment function. When splicing fibers and making
axial offset at [PAUSE], it is recommended to use the manual
splice mode instead of setting this function to "OFF."
The re-arcing process sometimes improves the splice loss, but
sometimes worsens it. Re-arcing decreases the splice strength.
With this function, it is possible to limit the number of re-arcs or
to disable re-arc discharge.
the Fusion Splicer. This machine can store up to 4000
memories of the Fusion Splicer.
to enter, then the [Memory clear] menu is displayed.
and move the cursor to select the [Display
Manual de usuario AD300
AD Instruments
and move
to enter; then the [Select
138