Auto Calibration And Splice; Splice Loss Estimation - ADInstruments AD300 Manual De Usuario

_____________________________________________________________________
fusion fiber according to the oneself's need for fusion index, and
editor in [creating splice mode] of this user manual.
<2> Even if no error message appears indicating that the measured
fiber cutting angle is greater than the set limits, the operator
should also check artificial the fiber end face. If the similar
following situation is found, remove the fiber from the fusion
splicer, and then make re-preparation. Surface defect of the fiber
may lead to a failure of the fusion.
<3> The quality of fiber end face has enormous impact on the loss of
the contacting point; so efforts should be mad as possible to make
the end face plane, and the angle of the place with the fiber
cross-sectional plane should be less than 1 °. Figure Five (a) is a
good end face, which can be fused. (b) to (f) are ineligible face
end, which should be re-done.
(a) good end face q
serrated
(d) lack of corner

4.3.2 Auto calibration and splice

After the inspection of fiber, it will be aimed accurately in
accordance with the core-core or cladding-cladding manners.
After completion of fiber alignment, arc discharge is
performed to splice the fibers.

4.3.3 Splice loss estimation

Estimated splice loss is displayed upon completion of splicing.
©Copyright Abacanto Digital SA.
(b) a sharp convex
(e) fovea
Manual de usuario AD300
AD Instruments
(c)
(f) tortoise moiré
161