Change Parameters - ADInstruments AD300 Manual De Usuario

_____________________________________________________________________

3.3.2 Change parameters

In the
cursor to select a parameter to change; press
the change of the parameter. Press
previous operation interface.
<1> Monitor Position
The default set is fronting. To change monitor position to the
rear, turn the monitor along the fixed frame to a desired
angle; then in the "Application Menu" move the cursor to the
[Monitor Position] option. Press
changed.
<2> Power Save
This function is important for energy conservation. If the
power saving function is not set during battery pack use, the
service life of the battery and the monitor will be shortened.
When this function is active, the splicer automatically enters
into sleeping mode or powers off in the specified time.
Power Save
Sleeping mode
a. In the Application Menu, press
cursor to the [Power Save] option.
©Copyright Abacanto Digital SA.
Application Menu, press
Manual de usuario AD300
AD Instruments
or and move the
to confirm
to return to the
, the Monitor Position is
or and move the
143