Vibration Specifications; Scope Of Supply; Safety Devices; Use According To Intended Purpose - Mafell MF 26 cc Manual De Instrucciones

machining and the environmental influences. The noise rating level can therefore only be determined on an
individual basis at the machine user's position.

2.5 Vibration specifications

The typical hand-arm vibration is 3.6 m/s

2.6 Scope of supply

Groove-cutting machine MF26cc complete with:
1 milling tool
1 saw blade (for MAX aluminium with 40 teeth, for MAX construction, GF and KSS wood with 24 teeth)
2 position indicators
1 parallel stop cpl.
2 operating tools
1 hose connector
1 chip deflector (only for model MAX aluminium)
1 carrying case (for models 917801, 917820, 917821, 917822, 917823, 917825, 917802, 917840, 917841,
917842, 917843, 917845, 987420)
1 transport case (for models 917804, 917880, 917881, 917882, 917883, 917885)
1 operating manual
1 folder "Safety Instructions"

2.7 Safety devices

Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative.
The machine is equipped with the following safety
devices:
- Upper stationary saw guard
- Lower retractable saw guard
- Large base plate
- Handles
- Index mechanism and brake
- Hose connector

2.8 Use according to intended purpose

The groove-cutting machine is exclusively suited for
longitudinal and cross cutting as well as for milling
solid wood, panel materials such as chip board,
coreboard, MDF board, gypsum plasterboard,
aluminium compound panels and laminate panels.
Special use of the tools:
2 .
- The saw blade is exclusively suited for processing
wood, plaster board panels, aluminium compound
and laminate panels.
- The slitting unit (special accessories) is exclusively
suited for processing wood and plaster board
panels.
- The adjustable groove cutter is exclusively suited
for machining wood.
- The plasterboard milling cutter is exclusively suited
for processing wood and plaster board panels.
- The aluminium compound milling cutter is
exclusively suited for machining aluminium
compound panels.
Only use the approved tools. Our tools are
manufactured according to EN 847-1. Any other use
than described above is not permissible. The
manufacturer cannot be held liable for any damage
arising from such other use.
To use the machine as intended, comply with the
operating, maintenance and servicing conditions
prescribed by Mafell.
-23-