Assembly And Preparation For Operation - Unold 58550 Instrucciones De Uso

28. Check the appliance, the plug and
the power cord regularly for wear
or damage. In case of damage to
the power cord or other parts, ple-
ase send the appliance, or only
the heating element, for inspec-
CAUTION:
The appliance becomes very hot during operation!
Never open the housing of the appliance. This can result in electric shock.
The manufacturer will not be liable in the event of incorrect assembly, improper or incorrect use or if
repairs are carried out by unauthorized third parties.

ASSEMBLY AND PREPARATION FOR OPERATION

1. Remove all packaging materials.
2. Clean all parts with a damp
cloth, as described in the chapter
"Cleaning and care".
3. Push the legs (8) through the
holes in the tray (7).
4. Set up the stand, and if necessary
turn the stand legs to that the
appliance stands stably. If neces-
sary, push the end caps for the
legs into position.
5. Push the tubes (6) up into the
holes in the tray.
6. Press the insert (5) onto the stand
by applying pressure to it.
7. Fix the spacers (4) into the reces-
ses provided for this purpose on
the insert. In doing so, the side
with the three openings must face
upwards.
8. Insert the provided handles (wit-
hout picture) in the grill housing
insert (part no. 5) by pressing
them from below in the respective
groove, until the clutch engages.
9. A sure transport of the device is
guaranteed by the handles.
10. Place the water tray (3) onto
the opening in the insert. Please
20
tion and/or repair to our after sales
service. Unauthorized repairs can
result in serious risks to the user
and void the warranty.
ensure that the two openings on
the water tray face upwards on the
insert as a recess for the heating
element (2).
11. Ensure that the grill table is sta-
ble.
12. Fill the water tray with at least
400 ml of water. Never operate
the grill without first filling the
water tray.
13. Insert the heating element (2).
The insert is correspondingly
recessed for the control unit. Ple-
ase insert the heating element
very firmly, as otherwise the built-
in safety switch on the lower side
of the control unit prevents the
appliance from being switched on.
14. Place the grill grate (1) into posi-
tion.
15. Check to make sure that all parts
have been assembled correctly.
16. Connect the appliance via the
power cable to the power supply
(AC, 230 V~, 50 Hz).