Assembly & Operating Instructions - SKF 729101 Instrucciones De Uso

3 ASSEMBLY & OPERATING INSTRUCTIONS
If adapter block is to be used on a relatively flat
surface, put the telescopic steel pipe in
corresponding slot of adapter block. Lock it in
position with the quick action lock screw.
The adapter block can also easily be locked on the
top of a working bench by means of a standard
GH-clamp. It can also be clamped in a vice.
Screw the oil injector on the adapter block until the
thread can be seen in the inside slot.
Screw the rectangular gauge adapter nipple into
the thread of the pressure gauge tightly, so that a
good seal is formed. Make sure the flat surfaces of
the nipple are aligned with the pressure gauge.
This nipple will remain on the gauge.
10
B
A
A Quick action locking screw
B Adapter block
C Telescopic steel bar
A
A Gauge adapter nipple
C
A
SKF 729101