SKF 729101 Instrucciones De Uso página 13

When the oil reservoir (H) is to be charged, the nozzle is immersed in oil and the
piston retracted by the handle. The oil will then be sucked into the reservoir.
To allow any air to escape, point the nozzle upwards and depress the valve ball
slightly. Screw the reservoir onto the injector, the ball is automatically depressed
and the valve opened. Open the release valve (F) slightly. Pump a few strokes with
the handle until clean oil, free from air bubbles, issues between the injector body
and the forked lever. Tighten release valve (F).
Please note that the oil reservoir can be refilled without releasing the pressure
from the pump.
A repair kit, which contains ball A, C and E, together with pin B and D is available
(see spare parts list).
The kit is now fully assembled and ready for use.
Before using the oil injection method, always
ensure that all air has been released from the
hydraulic system.
SKF 729101 13