S&P CB-2002 Instrucciones De Montaje página 13

0
+5 C the appliance will automatically switch ON keeping the room at this
constant temperature. This device is very useful where low temperatures are
common and where pipeline water is easily frosted.
Operation of Model CB-2002T (Fig.6)
ON /OFF & Thermostat Selector Switch.
0 =
=
( ) =
*
( ) =
1. Ensure the Timer Switch is in the position (0).
2. Turn the Thermostat Selector Switch to maximum position.
3. This appliance operates at a 1000W heat output as standard. Indication of
power supply and operation is provided by the illumination of the small neon
light.
4. The first time the unit is switched ON, the surrounding environment will heat
up accordingly. When the desired temperature of the environment has been
reached, turn the Thermostat Selector Switch down until a "click" is heard.
The unit will switch OFF.
When the thermostat is in this position the appliance will automatically switch
ON and OFF to maintain this desired temperature.
Timer switch
0 = Position OFF
Regulate between 5 –60 mins. = Select the operation time required by
turning the Timer Switch accordingly. When using the Timer, the heat output
is 1800W, and operates independantly from the Thermostat Switch. Therefore
when using the Timer function the Thermostat will not operate. When the
Timer period has elapsed, the appliance will revert back to the operation at
1000W via the Thermostat Switch.
AUTOMATIC ANTI-FROST DEVICE CB-2002T
The CB-2002T wall mounted heater incorporates as standard an Anti-Frost
Protection Device which switches the unit ON automatically when the
temperature is less than +5
in use, simply ensure the Timer Switch switch is at position 0, and then turn
the Thermostat to position ( ). Therefore when the temperature drops below
OFF
1000W
Frost Protector & Minimum Thermostat Position
Maximum Thermostat Position
0
C. To activate this device when the heater is not
*
12