MRA BMW G310GS 2017 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
2 Distance sleeves M6 20mm
2 Distance sleeves 15mm
2 Lens head screws, M5x35mm
2 Lens head screws, M5x30mm
4 Plastic discs 12x5x0.5mm
4 O-rings, 4.5x1.5mm
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the original windscreen.
3. Insert the M5x35mm lens head screws [10632] with the plastic washers [10635] into
the upper holes on the MRA windscreen. Then, slide the 20mm distance sleeves
[11181] onto the lens head screws [10632] from the back and secure these with the
provided o-rings [10992].
4. Insert the M5x30mm lens head screws [10556] with the plastic washers [10635] into
the lower holes on the MRA windscreen. Then, slide the 15mm distance sleeves
[10636] onto the lens head screws [10566] from the back and secure these with the
provided o-rings [10992] as well.
5. Attach the MRA windscreen to the motorbike and centre the windscreen. Fully tighten
the lens head screws.
6. Attach the provided edge protector shown in image 2 to the windscreen.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorized workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW G310GS 2017-
Article No..
--- Allen key 3mm
Torx T30
11181
10636
10632
10566
10635
10992
3
Required tools