Leveling Refrigerator - Amana BB20VPSE-P1321308WB Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

!
To avoid property damage, protect soft vinyl or other
flooring with cardboard, rugs, or other protective
material when moving refrigerator.

Leveling Refrigerator

Some installation may require door reversal to achieve full
door swing. If so proceed to Door Reversal section before
leveling your refrigerator.
If your refrigerator requires ice maker water supply
connection, proceed to Connect Ice Maker Water Supply
section before leveling refrigerator.
1. Plug in power cord.
2. Move refrigerator into final location.
3. Level refrigerator using a level placed on top of the
refrigerator.
• Remove toe grille by grasping both ends and pulling
straight out from unit. Grille snaps free.
• The left and right corners of front cabinet base each
contain 2 screws to allow individual adjustment of all
four corners. Adjust the front and rear of each corner
until leveling is complete.
A
B
A Rear roller adjustment
B Front roller adjustment
• Turn roller adjustment screws to the right to raise
cabinet, or to the left to lower cabinet. Front of
refrigerator must be ¼" (6 mm), or ½ bubble on your
level, higher than the back of your refrigerator.
• After leveling, turn stabilizing leg (some models) to
the right until firmly against floor.
• Locate metal clips mounted to inside of toe grille
assembly. Hook bottom set of clips inside metal
molding beneath freezer. Press forward on upper
part of grille until top portion snaps into place.
A Metal clips
CAUTION
C
C Stabilizing leg*
*some models
A
9

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido