Bulb Replacement - BFT BOTTICELLI VENERE Instrucciones De Uso

ENGLISH
Thank you for buying this product, our company is sure that you will be more
than satisfied with the product's performance. The product is supplied with
a "Warning" leaflet and an " Instruction booklet ". These should both be
read carefully as they provide important information about safety, installa-
tion, operation and maintenance. This product complies with the recognised
conformity with the following European Directives: 89/336/EEC, 73/23/EEC,
98/37/EEC, 99/05/EEC (and subsequent amendments).
1)GENERAL OUTLINE
The BOTTICELLI system is compatible with the EElink protocol for fast in-
stallation and maintenance. It is suitable for motorising sectional doors, pro-
truding fully retracting spring operated overhead doors and counterweight
overhead doors provided with an appropriate towing arm. The overhead door
must not be higher than 3 metres. It is easy to install and fast to fit and does
not need the door to be modified. The irreversible gearmotor keeps the door
locked in the closing position. The control unit is builtin. It controls the opera-
tion relays and the safety devices (photocell, rubber skirt) before performing
every manoeuvre.
This product was designed to motorise the types of door mentioned
above. Any other use is considered contrary to that intended by the
manufacturer who,therefore,cannot be held responsible for any injuries
to persons or animals,or damage to things which might derive from
misuse.
2)SAFETY
If correctly installed and used, this automation device satisfies the required
safety level standards. However, it is advisable to observe some practical rules
in order to avoid accidental problems. Before using the automation device,
carefully read the operation instructions and keep them for future reference.
particularly during operation.
to avoid any unintentional automation activation.
4 -
BOTTICELLI VENERE
USER'S MANUAL
not been released by pulling the appropriate wire connected to the carriage
gency release to gain access to the automation device and request the
assistance of a qualified technician (installer).
mains powers supply.
vices clean. Check that the safety devices (photocells) are not obscured by
branches or shrubs.
of a qualified technician (installer).
to find out any unbalance, sign of wear or damage. Do not use the operator
in the case where any repairs or adjustments are required, given that an
installation malfunction or an incorrectly balanced door could cause inju-
ries.
50 mm away from the floor. Should operation show to be incorrect, request
the assistance of a qualified technician, given that an incorrect adjustment
could be dangerous.
3) EMERGENCY MANOEUVRE
In case of electric power failure or system malfunction, the manoeuvre must
be carried out manually by pulling the wire connected to the carriage, as in
(fig.3).
WARNING: If the door is not correctly balanced, activation of the carriage
manual release could provoke an uncontrolled door movement.

4) BULB REPLACEMENT

To replace the courtesy light bulb, remove its transparent cover (fig.4).
(SM1 or SET/S fig.2-fig.3) activated.
SM1 (fig.2) or Mod. SET/S
E14 24V
25W max
-
-