Denon D-107 Instrucciones De Operación página 7

J Connecting a CD receiver and subwoofer 1
• About mounting the main unit stand
Yuu will need a screwdriver to assemble
{1} Connect the system cable to the bottom of
_2_Run the system cable aroused to the back r line up the posit oning pin
of the ncEuded main unit stand with the hole in the
main unit, then mount with the included screws
Posit o/Jig pin/ole
Poskion[ng p4n
_3_Connect the plug on the opposite side of the system cable to the subwoofer
Connect with the wider part of the system cable's
connector facing upwards
Inset[ the plug securely, pressing it in aEIthe way it
will go
JConnecting the speakers 1
• About mounting the speaker stand
Paying attention to set the included
speaker stand n the proper fro_t/back
position, line up the positio_i_g pin with
the hole in the speaker, then mou_t it
with the included screws a_d fasten it
securely
Posit[onin(
_ Pos;tioning
pin hole
• Connecting the speakers and cords
• Use the included speaker cords to connect the speakers and subwoofer
• Connect the left channel speaker (the left side as soon from the front) to the "L" terminals, the right
channel speaker to the "R" terminals
_1_Lower the lever _2_lnsertthe speakercord ,_J-Return the lever
Connect the cord's coppeE-colored core wire to the
"+" side, the silver-colored core wire to the "" side
(copper colored)
i,
Core wre (silver colored)
"_ • Gently pull the cord to check that
it is securely connected
Core w_re
(coppepcolored
Co_e wire
=
• About mounting the cable cover [When mounting on the wall] (See page 8.)
Ru_ the system cable around to the back, line up the
Fro[it
NOTES:
• Be sure to unplug the power supply cord before
connecting the speakers
• Be sure to connect the speaker cords propedy {+
to+, to ,LtoLandRtoR)
• Do not shor[-circuit the speaker cords
if the power is turned on, accidentally short-
circuiting the speaker cords could cause damage
or accidents
• Be sure to connect the speaker to the speaker
terminals with the proper polarit es {+ to +,
..... to
if the polarities are wrong, the sound from the
center will be weak, the posit oning of the
instruments will be unclear and the stereo effect
will be poor
• Never play such special s gnals as sine waves or
the fast-forwarding signals of a tape recorder
continuously
7