Fixing Of Reduction Gear - Allmatic IND2500K Manual De Instrucciones

FIXING OF REDUCTION GEAR

Open the packaging and check the condition of all the parts of the automation.
• Remove the lid unscrewing the screws see (fig. 5).
• Place the reduction gear on the plate.
• Insert the 4 washers + locknuts to fix the gear (fig. 6).
• If the allowed adjustment of the ratchet is not sufficient it is possible to compensate the
height of the reduction gear working on the 4 more external screws (fig.6).
• Once the adjustment is finished firmly fix the 4 locknuts, making sure that during the entire
run of the gate, the reduction gear is firmly to the ground.
N.B. ANOTHER FIXING OF THE SCREWS IS ADVISABLE AFTER SEVERAL OPERATIONS
remove 2 screws
fig.5
fig.6
17
screws for the height
adjustment of the
reductioon gear
nuts for fixing the
reduction gear