Functional Description; Removing/Inserting The Battery - Milwaukee M18 FUEL ANGLER 2873-20 Manual Del Operador

FUNCTIONAL DESCRIPTION

2
1
1
1. Latches
2. Nozzle notch
3. Trigger
4. Control switch
5. Handle
6. Nozzle
7. Hub
8. Drum grips
9. Drum
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Installing a Drum
1. Align the nozzle of the drum to the nozzle notch
of the tool and place the drum around the tool hub
until fully seated.
2. Secure the drum to the tool with the three latches.
3. To remove, unlatch and use drum removal grips
to separate the drum from the tool.
3
4
5
6
1
7
8
9
OPERATION
To reduce the risk of injury, always
WARNING
wear proper eye protection marked
to comply with ANSI Z87.1.
Maintain proper footing and bal-
WARNING
ance when performing pulling
operations. Do not pull from a ladder. If a snag or
resistance is encountered, a ladder could become
unstable which may result in a loss of balance or
control.
Using the Control Switch
The control switch may be set to three positions:
feed, retract and lock. Due to a lockout mechanism,
the control switch can only be adjusted when the
trigger is not pulled. Always allow the motor to come
to a complete stop before using the control switch.
1. To feed the fish tape, push the control switch in
the direction shown.
PUSH TO CENTER TO LOCK
Push for
Retract
2. To retract the fish tape, push the control switch in
the direction shown.
3. To lock the trigger, push the control switch to the
center position. The trigger will not work when the
control switch is in the locked position.
Always remove the battery pack before performing
maintenance, changing accessories, storing the
tool and any time the tool is not in use.
General Operation
1. Install the battery pack.
2. Support fish tape during use.
3. To feed the conduit run, move the control switch
to the feed position
4. To vary the speed, increase or decrease pressure
on the trigger. The further the trigger is pulled, the
greater the speed.
5. While extending, monitor the fish tape. When
nearing full extension, the fish tape will be marked
with yellow paint. Once yellow paint is visible, stop
extending. Further extension could damage or
break the fish tape.
6. Once the fish tape has been extended out to the
pulling point, release the trigger.
7. Move the control switch to the Lock position or
remove the battery pack.
8. Fasten your wire or pull line to the fish tape se-
curely. Wrapping the connection with plastic tape
may help prevent it from unraveling during pulling.
4
Push for
Feed
and pull the trigger.