One cooling zone
o There is one cooling zone inside of your wine cabinet.
o The cooling zone has a temperature control and temperature display.
Interior light
o The cooling zone has an interior light. The light can be switched on and off by using the light
control button (2).
The wine cabinet shelves
o The wooden shelves are fully adjustable to suit various wine bottle shapes and sizes.
o To prevent damaging the door gasket, make sure the door is fully open when pulling the shelves
out of the rail compartment.
o For easy access to the bottles stored, pull the shelves out approximately 1/3 of the way.
Using your wine cabinet
Before switching on
o Make sure that it has been installed by a suitably qualified person, as per the information
contained in HKoenig's installation instructions.
o After delivery, wait for eight hours before connecting the appliance to your mains supply. This
will allow any refrigerant gasses that may have been disturbed during the transportation
process to settle.
o The outside of the appliance and the removable accessories contained within it, should be
cleaned with a solution of liquid detergent and water.
o The interior of the appliance should be cleaned with a solution of sodium bicarbonate dissolved
in lukewarm water. The interior and accessories should be thoroughly dried, after the cleaning
process has been completed.
o There can be an odour when you first switch on the appliance. It will lessen as the appliance
starts to cool.
During first use
IMPORTANT: When you use the wine cabinet for the first time or restart the appliance after it
has been turned off for a long time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED display. This is normal and it is due
to the length of activation time. Once the wine cabinet has been running for a few hours
everything will be back to normal.
o When you first switch on the appliance, the compressor will run continuously until the wine
cabinet reaches a cool enough temperature.
7