Fitting The Splinterguard - Festool PRECISIO Serie Instrucciones De Servicio

14.8 Fitting the splinterguard

The splinterguard SP-CS 70 (Order No. 490 339,
included with the CS 70 EB) prevents splinters in
the lower cut edge of the workpiece during vertical
cuts (saw blade in 0° position).
Warning: bevel cuts are not possible with the
splinterguard!
The splinterguard should thus be removed
immediately after use.
Ÿ Unplug the mains lead from the wall socket!
Ÿ Release insert clamp with rotary knob (5.1), push
claw forwards.
Ÿ Raise and remove the base runner (1.4) at the
rear.
Ÿ Set saw blade to minimum cutting depth.
Ÿ Push splinterguard (8.1) from the side into the
holder (8.2) up to the stop.
Ÿ Replace base runner and plug mains lead into
wall socket.
Ÿ Switch on tool and slowly move the saw blade up
to the maximum cutting depth – this cuts the
splinterguard to shape.
For a optimum function the raised part (8.4) of the
splinterguard should protrude slightly (approx.
0.3 mm) above the surface of the base runner.
For this purpose the height of the holder (8.3) can
be adjusted after releasing both screws (8.1).
14.9 Fitting a screw clamp
A screw clamp (Order no. 489570) can be inserted
into the groove (1.10). Workpieces can be clamped
in place with the screw clamp.
15 Miscellaneous
Warranty
Our equipment is under warranty for at least 12
months with regard to material or production faults
in accordance with national legislation.
In the EU countries, the warranty period is 24 months
(an invoice or delivery note is required as proof of
purchase).
Damage resulting from, in particular, normal wear
and tear, overloading, improper handling, or caused
by the user or other damage caused by not
following the operating instructions, or any fault
acknowledged at the time of purchase, is not
covered by the warranty.
Complaints will only be acknowledged if the
equipment has not been dismantled before being
sent back to the suppliers or to an authorised
Festool customer support workshop.
Store the operating instructions, safety notes, spa-
re parts list and proof of purchase in a safe place.
In addition, the manufacturer’s current warranty
conditions apply.
Note
We reserve the right to make changes to the
technical data contained in this information as a
result of ongoing research and development work.
17