Precautions For Safety And Use - Teka LI4 1470 E Manual De Instrucciones

READ THE INSTRUCTIONS
Attention!
You are advised to read all the instructions in this manual carefully; it will inform
you about the right conditions for the proper, safe use of your washing machine.
It is very important to keep this instruction manual with the appliance for future ref-
erence.
In the event of sale or transfer, ensure that the manual always accompanies the
appliance, to provide the necessary information about its use.

1. PRECAUTIONS FOR SAFETY AND USE

Attention!
These precautions are detailed for reasons of safety.
This section must be read carefully before installation and use.
Disposing of packaging
Never leave packaging residues unattended in the home. Separate waste packaging materials by
•
type and consign them to the nearest recycling centre.
Packaging materials (plastic bags, polystyrene, etc.) must not be left within reach of children.
•
Disposing of old appliances
Once no longer in use, the appliance must be rendered unusable: permanently disarm the
•
lock on the door (this will prevent children risking their lives by locking themselves inside
during play) and cut the power supply lead after removing the plug from the socket.
The appliance must be delivered to a recycling facility.
Environmental protection
Use the whole of the maximum recommended capacity. Never exceed the maximum permitted lo-
•
ad.
Do not use the prewash function for lightly or normally soiled items.
•
Follow the manufacturer's recommendations on detergent usage.
•
Use the highest spin speed permitted for the fabric type. Fast spins reduce the drying time and
•
thus energy consumption.
Safety instructions
This appliance is intended for domestic use and is compliant with Directives 72/23/EEC and
•
89/336/EEC (including Directives 92/31/EEC and 93/68/EEC) currently in force.
Read all the instructions in this manual carefully before installation and use.
•
Check that the drum assembly has been released before use (see instructions). Failure to release
•
the drum assembly may cause damage to the washing machine and the surrounding furniture or
appliances during the spin cycle.
This Instruction Manual is an integral part of the appliance: it must always be kept intact with the
•
appliance. Installation must be carried out by qualified staff in compliance with the relevant regula-
tions. The appliance is built to provide the following functions: washing and drying of clothes or fa-
brics stated to be suitable for machine washing by the producer on the relevant label. All other u-
ses are to be considered improper. The manufacturer declines all liability for uses other than
those stated above.
The nameplate with the technical data, serial number and mark is in a visible position in the part in
•
view after the door has been opened. The nameplate must never be removed.
The electrical and plumbing works required to install the appliance must only be carried out
•
by skilled staff.
The appliance must be connected to earth in compliance with electrical system safety regulations.
•
The manufacturer declines all liability for direct or indirect injury or damage deriving from a
non-existent or defective earth connection.
In the event that the appliance is not connected by means of a plug, an omnipolar circuit-breaker
•
device with contact gap of at least 3 mm must be provided.
The plug to be connected to the power supply lead and the relative socket must be of the same
•
type and comply with the relevant regulations. Check that the mains voltage and frequency are the
EN
2