Stihl BR 450 Manual De Instrucciones página 19

Ocultar thumbs Ver también para BR 450:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Never remove the cap by turning it
directly to the open position. Turn it
first approximately 1/2 of a turn
counter-clockwise to relieve any
residual pressure.
Never open the fuel tank while the
engine is still hot or running.
Never open the fuel tank or re-fuel
the power tool near any sparks,
flames or other ignition sources.
Pick the right fuel: use only good
quality (89 octane or higher), fresh
fuel blended for the season.
Vapor lock: do not remove the fuel
cap in an effort to relieve vapor lock.
Removing the cap has no effect on
vapor lock.
Be aware that fuel spraying is more
likely at higher altitudes.
Preparations
Before fueling, clean the filler cap
N
and the area around it to ensure that
no dirt falls into the tank.
Position the machine so that the
N
filler cap is facing up.
BR 450, BR 450 C
WARNING
In order to reduce the risk of fire and
other personal injury from escaping gas
vapor and fumes, remove the fuel filler
cap slowly and carefully so as to allow
any pressure build-up in the tank to
release slowly.
Opening
WARNING
After allowing the power tool to cool,
remove the fuel filler cap slowly and
carefully to allow any remaining
pressure build-up in the tank to release:
While maintaining steady,
N
downward pressure, slowly turn the
cap approximately a 1/2 turn
counter-clockwise.
If any significant venting occurs,
N
immediately re-seal the tank by
turning the cap clockwise to the
closed position. Allow the power
tool to cool further before attempting
to open the tank.
Turn the cap to the open position
N
only after the contents of the tank
are no longer under pressure.
Remove the fuel filler cap.
N
WARNING
Never remove the cap by turning it
directly to the open position. First allow
the power tool to cool adequately and
then release any residual pressure by
slowly turning the cap approximately
1/2 turn counter-clockwise. Never
attempt to remove the cap while the
engine is still hot or running.
Refueling
Take care not to spill fuel while fueling
and do not overfill the tank – leave
approximately 1/2" (13 mm) air space.
Closing
WARNING
An improperly tightened fuel filler cap
can loosen or come off and spill
quantities of fuel. To reduce the risk of
fuel spillage and fire from an improperly
installed fuel cap, tighten the fuel filler
cap by hand with as much force as
possible:
English
17

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Br 450 c

Tabla de contenido