Assembly - Truper SINCO-10X2 Manual De Instrucciones

Side extension arms
• The arms are useful to support work pieces exceeding
the cutting table area.
• To install onto the worktable loosen the extension arms
locks (25).
• With the help of the special wrench, remove the screw at
the end of each extension.
• Set the extension arms on both sides of the table.
Tighten the locks.
• With the help of the special wrench and the arms
mounted, tighten the screw that was previously
removed.
Miter lock
• Insert the lock (20) into the hole on the front of the
machine.
• Ensure that the thread assembles with the counter.
Dust collecting pouch
• Set the dust-collecting pouch (36) in the dust-collecting
chute (13) found in the back of the cutter head column.
Press
• To secure the work piece onto the cutting table use the
vertical press (21).
• Fix it in one of the orifices (23) regarding the job to do.
• To secure in place the vertical press, tighten the knob
firmly (22).
36
8 ENGLISH
25
24
20
13
22

Assembly

23
21